Skip to main content

dag 6 geen internet / hoog water high tide allert

“Inform all the troops that communications have completely broken down”

 

Maybe we can get some help from other more developed countries like Greece Romania to improve our communication infra struture.

We can pay in natural gas  since Groningen has one of the biggest N-G resource in Europe.


 Nog steeds een knipperend broadband ledje dus geen signaal op de lijn.Sinds vrijdag de dag dat KPN mijn ADSL lijn zou overzetten naar VDSL.   
Met de huidige stand van techniek is het blijkbaar niet mogelijk om een kabel in de centrale even om te schakelen.
Vroeger kon met simpel telefoontje met de PTT wel wat geregeld worden.
Maar nu dit ook vanuit het EU hoofdkantoor bureaucratisch wordt aangestuurd  volgens de OPTA regels is dit ook onmogelijk geworden.

Gisteren was het dan zover dat er een "monteur"  langs kon komen. Deze man had in no time vast gesteld dat VDSL  hier niet zou kunnen werken dat gaat tot maximaal ca 1800m  van de centrale.
ADSL 2+  zou wel passen in mijn situatie met een oudere kabel met meerdere? lassen over zo'n 5 a 10km naar de buiten ring kast.  Met ADSL 2+  zou ik hier dan12 a 16Mb kunnen halen.
Dat weten ze  blijkbaar niet bij de KPN helpdesk.
Mijn kabel lengte is op de cm nauwkeurig bekend en kan worden getest op kwaliteit vanuit de helpdesk.
Blijkbaar is er een enorme kloof tussen de veld dienst en de bureau dienst.


Bad radio propagation continues   weak VK4MA worked at 160m
Bad weather stormy wind and rain  since the snow and ice melted down in a few days time.
Closing the security gates in the harbour.
 
 
 

Comments

Archive

Show more

Popular posts from this blog

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its normal vertical mounting posit

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjusted at 50mA  5V  The current raises to 150mA  when removing the  negative gate voltage. Where is that internal bias cir

BIJZEN mast en ontwerp fouten.

In 2013 heb ik een Bijzen aluminium mast 3 x7m  opgehaald  bij iemand die hem niet mocht plaatsen Gemeente Oss  dat zegt misschien al genoeg.. Pas in 2018 heb ik hem geplaatst had ik veel eerder moeten doen. Mooie mast, mijn xyl vond hem zelfs mooi. Hij is licht, de 3 delen wegen  235kg  het vaste deel 102kg dus het te lieren gedeelte weegt   slechts 133kg + ca 50kg rotor + antennes etc.  De elektrische lier is wel erg zwaar 30kg misschien wel maar die zit onder    Antenne  3ele Steppir  19kG  +  G2500DXC rotor: 3.6kg  + rotorbuis 12 kg  +  kabels 10kg  + 5/7 ele 6m beam. ongeveer 50kg Je moet niet te dichtbij  kijken, dan valt op dat het Aluminium lastwerk heel slordig is gedaan, scherpe bramen aan de lassen waar kabels door kunnen worden beschadigd of haken Er is zeer ! weinig ruimte voor de rotor een YAESU G2500DX past net maar dan ook net  met beetje buigen van  kruisverband. Het Rotor platform kan wel een meter hoger dat geeft meer  buislengte boven het zit nu op 3.5 meter van het